Home
About Us
Contact Us
Bookmark
Saved Bookmarks
Current Affairs
General Knowledge
Chemical Engineering
UPSEE
BSNL
ISRO
BITSAT
Amazon
ORACLE
Verbal Ability
→
Networking
→
Wide Area Networks in Networking
→
What VTP mode allows you to change VLAN informatio...
1.
What VTP mode allows you to change VLAN information on the switch?
Answer» Only in server mode can you change VTP information on a switch.
Show Answer
Discussion
No Comment Found
Post Comment
Related InterviewSolutions
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?
A switch has been configured for three different VLANs: VLAN2, VLAN3, and VLAN4. A router has been added to provide communication between the VLANs. What type of interface is necessary on the router if only one connection is to be made between the router and the switch?
What VTP mode allows you to change VLAN information on the switch?
When a new trunk link is configured on an IOS-based switch, which VLANs are allowed over the link?
To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?
Which switching technology reduces the size of a broadcast domain?
You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?
Which command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Ethernet frames?
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies