To configure the VLAN trunking protocol to communicate VLAN informatio – InterviewSolution

1.	To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?
Answer» You must have the same VTP domain name on all switches in order to share VLAN information between the switches. At least one of the switches must be a VTP server; the other switches should be set to VTP client.

Discussion

No Comment Found

Related InterviewSolutions

Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?
A switch has been configured for three different VLANs: VLAN2, VLAN3, and VLAN4. A router has been added to provide communication between the VLANs. What type of interface is necessary on the router if only one connection is to be made between the router and the switch?
What VTP mode allows you to change VLAN information on the switch?
When a new trunk link is configured on an IOS-based switch, which VLANs are allowed over the link?
To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?
Which switching technology reduces the size of a broadcast domain?
You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?
Which command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Ethernet frames?