Explore topic-wise InterviewSolutions in Current Affairs.

ANSWER: here is your answer

Explanation:

In Case of the Elastic Collision, Kinetic ENERGY before and after the collision remains the CONSERVED, momentum also remains conserved.  

On This basis, Derivation in One dimension is shown in attachment.

The body of MASS m₁ is moving with the velocity u₁ and body of mass m₂ is moving with velocity u₂, after the collision there velocity became v₁ and v₂.

The Final Result is,

v₂ - v₁ = u₁ - u₂.

ANSWER:

FLOOR ......................

.

ANSWER:

forward means aage

and

reverse means peeche

PLEASE MARK as BRANLIEST

Answer:

DIRECT current (DC) is the FLOW of electric charge in only one direction.

Alternating current (AC) is the flow of electric charge that periodically REVERSES direction. If the SOURCE varies periodically, particularly sinusoidally, the circuit is known as an alternating current circuit.

ANSWER:

We SAY that there is motion if there is the change of surroundings ACCORDING to time.

Hope it helps you !

MARK me the brainliest !!!

Answer :-

Yes, when ice melts, heat is absorbed, but the temperature des not CHANGE. ALSO, when water refreezes, heat is GIVEN out, but the temperature does not change. This heat absorbed or given out is the latent heat.

HOPE it helps.

Thanks my answers.

Mark as brainliest.

Answer:

All the resistance less wires that have been ATTACHED in between the three pairs of 20,30 and 40,60 resistances can be removed due to the formation of a balanced Wheatstone Bridge.

So,

The PROBLEM is now simple ENOUGH to CALCULATE the parallel resistance of resistances 10,50,100 and 50.

So,

1/R = 1/10 + 1/50 + 1/100 + 1/50 = 10+2+2+1/100 = 15/100

So,

Equivalent resistance across the points P and Q is 100/15 ohms = 20/3 = 6.67 Ohms

ANSWER:

HOPE it HELPS.

MARK me as Brainliest.

Much love.

Thank you.

Given info : Volume of 100 liter gas increases to 120 liter at constant temperature and 10 bar external pressure.

To find : The workdone by the system is ..

solution : work done at constant temperature is given by, W = P∆V

here Pressure , P = 10 bar

and change in volume , ∆V = V₂ - V₁

= 120 litres - 100 litres

= 20 litres.

now workdone by the system = 10 bar × 20 litres

= 200 litre bar

but given, I litres bar = 24.21 cal

= 200 × 24.21 cal

= 4842 cal

Therefore the workdone by the system is 4842 cal.

also read similar questions : A gas at a volume of 4 LITERS is at a pressure of 2 atm. The volume is changed to 16 liters, what must the new pressure ...

brainly.in/question/17051630

a block of metal whose volume EXPANSIVITY is 5.0*10 and isothermal compressibility is 1.2*10 has volume 5 liter at 1atom...

brainly.in/question/685415

ANSWER:

BECOMES SHORTER when the cilliar MUSCLES RELAXES

EXPLANATION:

∆U=Q+W

=120+P∆V

=120+(101.32 * 1.4)

=120+(141.848)

∆U=261.848 JOULE

ANSWER:

POTENTIAL energy

Explanation:

MARK me as BRAINLIST

ANSWER:

both will reach at the same TIME as on an inclined PLANE gravity is same for all

Answer:

Odometer is the device used for measuring the distance travelled by the vehicles.

hope it will be HELPFUL ✌️

kr diya FOLLOW DIDI....!

Answer:

It is reverse biased configuration since the negative Side is CONNECTED to higher POTENTIAL TERMINAL which is ground at zero VOLTS and similarly the p-side is connected to the lower potential termimal which is -5 Volts.

Here are the advantages and disadvantages of using a solar COOKER:

Advantages:

• High Perfomance.
• Eco-friendly.
• No fuel.
• One time investment.

Disadvantages:

• Can't be USED in cloudy weather.
• Takes longer to cook.
• Need to learn SPECIAL METHODS to cook.

Please mark as brainliest if you found this helpful :)

Explanation:

1/2mv^2=mgh

m=M, v=LT^-1

g=LT^-2,h=L

Then....

ML^2T^-2=ML^2T^-2

Hence PROVED

Answer:

Resistance of base resistor is GIVEN as

Explanation:

As we know that voltage GAIN in COMMON EMITTER transistor is given as

also we know that CURRENT gain in this transistor is given as

#Learn

Topic : Transistor

brainly.in/question/7698522

EXPLANATION:

the position of the image is b/w focus and center of curvature . the nature of the image is inverted, DIMINISHED and real ....... HOPE u LIKE it

Answer:

The refractive index of the material of the convex lens is greater than the refractive index of the medium HENCE the light bends AWAY from the normal and diverges out. So, the relation between M1 and M2 is

M1>M2

hope it helps you plzz mark as brainliest if you LIKE it

Answer:

formula: WORK done = mgh

Explanation:

m=10 kg

g=10 m/s^2

h=10 m

Ans=> work done= 10*10*10

=1000 J

=1 kj

Explanation:

JOSEPH Marquis DUPLEIX (23 JANUARY 1697 – 10 NOVEMBER 1763) was Governor-General of French India and rival of ROBERT Clive.

51888 hair and make the PAYMENT to be happy birthday happy birthday to me so I am not the same the happy

Explanation:

hi please see attached the following URL Adobe FLASH I i and happy birthday from the day and I have a happy new YEAR the following the below mentioned details to follow up to date with all of the following link below to delete and I will COME over and over and let the day of work to get the latest the day and I will come back from a happy birthday from it all in my pride and pleasure ru and I in my u and I in eu and the other

HOPE it HELPS!!! PLEASE MARK As BRAINLIEST.

Boltzman CONSTANT=R/N

Where,

R=universal gas constant

=8.314Jmol^-1K^-1

N=avagadro NUMBER

=6.02x10^23mol^1

K=8.314Jmol^-1K^-1 / 6.02x10^23 mol^1

K=1.38x10^23Jmol^-2K^-1 :S.I. UNITS

=1.38x10^28ergmol^-2K^-1 : C.G.S units

Hope it helps you

PLEASE mark it as brainliest

I HOPE IT'S USEFUL FOR US. . . .

PLZ MARK ME AS BRAINLISTS. . . .

.......S MBA. ........

ANSWER:

by me KNOW when you have a GREAT TIME and I have

Answer:

Explanation:

STONE thrown from the tower

u = 0

g = -10 m/s2

s = - (200- x)

s= ut +1/2 at2

-(200 - x) = 0 - 1/2 10 X t2 ................................................. (1)

For UPWARD direction,

u = 20 m/s

g = -10 m/s2

s = +x

+x = 200 t - 1/2 10 t2 .............................................................(2)

Substracting 1 and 2, we get,

200 = 20t

t = 10s

x = 20 X 10 - 1/2 X 10 X 10 (square)

  = 200 - 500 m

  = 300 m

I don't know the answer

Sorry

EXPLANATION:

the earth BEHAVES like a MAGNET but there are no magnets inside the earth. the earth's magnetic north pole is in GEOGRAPHIC SOUTH.

ANSWER:

fhxhbxoc fqhfum jlfmuckgjf9e7xlur

Answer:

ZERO

Explanation:

As the charges on a conductor are CONFINED to its SURFACE and no charge is enclosed inside the sphere.

So, by gauss's law

As the charge is zero inside the conductor, hence the ELECTRIC flux is zero inside the conductor and thus, the Electric FIELD intensity is zero inside the conductor.

ANSWER:

PLEASE MARK it as BRAINLIEST , if it is CORRECT.

FALSE BECOZ it is not in ABDOMINAL CAVITY.

Answer:hguhjij HI jjhjvhjn in SUNNY hung

Explanation:

But BOOK club GO in early in Friday on Friday in vgyuhb

hello MATE here's your ANSWER for your Question is

MICROPHONE

if you like it MARK this as brainliest Answer

Answer:

as u put m2 with 2M2 in Gm1m2/d² then formula of F gone change to Gm12m2/d²..

PLEASE m2 REPLACE 2m2

if u LIKE please mark as brainlist answer

Answer:

sory for inconvenience

EXPLANATION:dear FRIEND im not expert in PHYSICS ill help u in others

ANSWER:

PLATING a ELEMENT OVEN another with the use of electricity

Answer:

Applications of the Heating Effect of CURRENT (1) The heating effect of electric current is utilised in the WORKING of electrical heating appliances such as electric ROOM heater, electric iron, electric kettle, electric toaster, electric oven, water heater (geyser), IMMERSION rod, and SOLDERING iron, etc.

Explanation:

I hope it helps you...

the soles of shoes are worn out due to the EFFECT of friction . the soles of shoes increase the friction between surfaces because it makes the SURFACE of the shoes rough . thus , this is due to the FACT that friction CAUSES wear and tear of objects and REDUCES the life of the object .

•Increase : Heat ADDED to the system increases the INTERNAL energy. Heat removed from the system decreases the internal energy. In a cyclic process the system returns to its initial state and so the internal energy is not changed. The heat added to the system equals the work done by the system.

•Remains constant : In an isothermal process, the temperature of the IDEAL gas remains constant. In a cyclic process, the initial and final temperatures (states) are the same. The internal energy of the gas is a function of temperature, hence if the temperature of initial and final states is the same.

•Decrease : Heat added to the system increases the internal energy. Heat removed from the system decreases the internal energy. In a cyclic process the system returns to its initial state and so the internal energy is not changed. The heat added to the system equals the work done by the system.

•Become zero : The internal energy does not become zero for any system except at the ABSOLUTE Zero of temperature. ... But by returning after each completed cycle to the original state, that GUARANTEES the system returns to the initial temperature. And the internal energy of an ideal gas only depends on its temperature.

Hope it helps uh.....

Mark me as brainlist.....

The basic element in geometrical optics is the light ray, a hypothetical construct that indicates the direction of the propagation of light at any point in space. The origin of this concept dates back to early speculations regarding the nature of light. By the 17TH century the Pythagorean notion of visual RAYS had long been abandoned, but the observation that light travels in straight lines led naturally to the development of the ray concept. It is easy to IMAGINE representing a narrow beam of light by a collection of parallel arrows—a bundle of rays. As the beam of light moves from one medium to another, reflects off surfaces, disperses, or comes to a focus, the bundle of rays TRACES the beam’s progress in a simple geometrical manner.

The EFFICIENCY of the CARNOT HEAT ENGINE is 100% .

The

ENERGY

stored in a BODY which is RESTING is CALLED POTENTIAL energy

both are of the same WEIGHT..........

≡QUESTION≡

If two soap BUBBLES have radii in the ratio of 1:2 then what is the ratio of  the excess pressure ?​

║⊕ANSWER⊕║

The excess pressure inside a soap bubble is denoted by the formula:

Δ P = 4S / R

Excess pressure is INVERSELY proportional to the radius for a GIVEN fluid.

GIVEN

R₁/R₂ = 1/2

p₁/p₂ = (4S/R₁) / (4S/R₂)

p₁/p₂ = R₂/R₁

p₁/p₂ = 2/1

∴ The ratio of excess pressure in the two soap bubbles will be in the ratio 2:1 (INVERSE of radius ratio).

≡QUESTION≡

You FIND your MASS to be 42 KG on a weighing MACHINE. Is your mass more or less than 42 kg?

SOMETHING YOU SHOULD KNOW FIRST

• A weighing machine measures the weight of a body

• When we stand on a weighing machine, our weight acts downwards while upthrust due to air acts upwards.

So, due to upthrust , the body appears to loose some weight.

As a result, our apparent weight becomes less than the true weight.

║⊕ANSWER⊕║

• The weighing machine measures this apparent weight and hence the mass indicated by it is less than the ACTUAL mass.

• Our actual mass will be more than 42 kg.

ANSWER:

HYY MATE... ✌

converts electrical ENERY into mechanical energy....

HOPE IT HELPS U....

when the VOLUME INCREASES the DENSITY of the SOLID decreses

mark as breinliest

EXPLANATION:

A progressive WAVE is a wave where continuous energy transfer takes place between the crest and through(TRANSFERS wave) or between rarefactions and compressions. There are two TYPES of wave transverse and longitudinal Amplotude is the maximum DISPLACEMENT of a particle In a wave from it's equilibrium position