Explore topic-wise InterviewSolutions in Current Affairs.

it has SINGLE COVALENT BOND because it is under ALKANES GROUP

"The five ISOMERS of HEXANE are: hexane, 2-methylpentane, 3-methylpentane, 2,2-dimethylbutane, and 2,3-dimethylbutane. They are CONSTITUTIONAL isomers because they each contain exactly the same NUMBER and type of ATOMS, in this case, six carbons and 14 hydrogens and no other atoms.

hexaammien COBALT (III) CHLORIDE

When SI is doped with As, FOUR electron of As forms COVALENT BOND with the four electrons of Si while one electron remains free for conduction. N- type of semiconductor is denoted by positive ION and free electron. Therefore, n-type of semiconductor is formed when Si is doped with As or any other pentavalent atom


hope it's help you. .....❤✌❤☺❤

........................

Ziner breakdown voltage occurs in a SEMICONDUCTOR DIODE when this is the ANS

If U wanna name of metals only .. FOLLOWING is the ans ..

Na . Mg .Al .si.p. sc.ti cr. MN .Ni. FE .co zn. K .ca.Bi . Rb li.Be ...Sb As...

Hope it will help u .

Name harry

Hey There! Carbon atoms in the benzene ring have a trigonal planar GEOMETRY around them since the carry bonds with three other groups and therefore, the HYBRIDIZATION is SP2 . This hybridization is a must to achieve the BOND angle 120∘ which is FOUND in benzene rings.




PLEASE MARK ME BRAINLIEST

IUPAC
name of the COMPOUND is pentyne


hope it HELPS you

Its IUPAC NAME is PROPANOIC ACID

The GEOMETRY of carboniun ION is PLANAR

it is an ORGANIC COMPOUND

Starch GELATINIZATION is a process of breaking down the intermolecular bonds of starchmolecules in the presence of water and heat, allowing the hydrogen bonding sites (the hydroxyl hydrogen and oxygen) to engage more water. This irreversibly dissolves the starch granule in water. Water acts as aplasticizer. Three main processes happen to the starch granule: granule swelling, crystal or DOUBLE helical melting, and amylose leaching.

During heating, water is first absorbed in the amorphous space of starch, which leads to a swelling phenomenon.[1]Water then enters VIA amorphous regions the tightly bound areas of double helicalstructures of amylopectin. At ambient temperatures these CRYSTALLINE regions do not allow water to enter. Heat causes such regions to become diffuse, the amylose chains begin to dissolve, to separate into anamorphous form and the number and size of crystalline regions decreases. Under the microscope in polarized light starch loses its birefringence and its extinction cross. [2]Penetration of water thus increases the randomness in the starch granule structure, and causes swelling, eventually amylose molecules leach into the surrounding water and the granule structure disintegrates.

Because it have VARIABLE OXIDATION NUMBER

solution:

6) Law of conservation of Mass - It states that mass is CONSERVED in any REACTION.

Mass of reactants = mass of products

Example:-

C + O₂ = CO₂

mass of carbon = 12u

mass of oxygen = 16u

In a reaction,

reactants, 12 u  + 2×16 u = 44u

products = 12 u  + 2×16 u = 44u

Thus mass of reactant = mass of product

Law of constant propotion:- it says that,  a chemical molecule will always contains the same elements in the same proportion.

Example:- water MOLECULES always contain Hydrogen and oxygen in 1:2.

7) Dalton's atomic theory:- He syas that, all elements are made up of small indivisble particles called atoms.

All atoms of the same elemnts are identical in all respects.

⊕ Limitation of dalton's atomic theory:-

1. Atoms are devisible [electron,proton and neutron]

2.All atoms are not identicals, like isotpes of carbon have diffrent mass[C¹²,C¹⁴]

8. a)Atoms:- Atom is the smallest PARTICLE on any element [while atoms furthuer can be devided in electron,proton and neutron].

b) Molecule:- Molecule is made up of More than two atoms of diffrent elemnts or same.

like- H₂ ,O₂, H₂SO₄ etc.

C) Atomic mass:- sum of Mass of total protons and neutrons is called atomic mass.

9.a) H₂O

2(1) + 16 = 18g/mol

b) H₂SO₄

2(1) + 32 + 4(16) = 98g/mol

c) HNO₃

1 + 14 + 2(16) = 47g/mol

______________________

Amrit______

Is there are any OPTIONS for this QUESTION?

The visualisation below presents the FOSSIL fuel CONSUMPTION mix across INDIVIDUAL countries ..... pre-industrial temperatures, we can emit only a limited AMOUNT of greenhouse GASES.

When U put sodium carbonate in water it produces 2 sodium ION and 1 carbonate ion

CARBON and OXYGEN MAYBE..!

When BAKING SODA is heated, sodium carbonate, water and CO2 are produced. Sodium carbonate obtained is DISSOLVED in water and CRYSTALS of WASHING soda are obtained by crystallization.

When an acid REACTS with metal OXIDE it PRODUCES salt and liberates hydrogen GAS.

Heya
yes we can check because detergent forms lather EVEN with HARD water where as SOAP does not FORM lather.soap only gives out scum.
hope it HELPS

Alligation METHOD of preparation of weak iodine solution from strong iodine solution

You need to have the following reagents and chemicals

1. Potassium iodide: 10 g

2. Distilled water: 100 ml

3. Iodine crystals: 5 g.

Preparation: A. Dissolve 10 g potassium iodide in 100 ml of distilled water. B. Slowly add 5 g iodine crystals, while shaking vigorously. C. Filter and store in a tightly stoppered brown bottle to prevent the solution prepared from being DECOMPOSED with light.

This solution has the name of Lugol's iodine solution.

In case of chloro benzene, if it loses chlorine it will GIVE C6H5 ion which is very unstable so it will not tend to lose Cl HENCE it is not reactive :) In case of CHLORAL benzene,chlorine is directly at tached to the hybridised carbon of the RING. Chlorine is deactivating and directing.

he ATOMIC weight of AgNO3 is 169.87 g/mol. SIMPLY DIVIDE the NUMBER of grams by the molar mass

                       17/169.87=0.10007

There is no electronegativity of compound. There is electronegativity of a ELEMENT and orbital electronegativity, only. Compounds are USUALLY neutral.

Well generally electronegativity is more of something that you THINK of in relation to an ATOM. You can look up charts and periodic tables that have atomic electronegativity listed.

For compounds, if the atoms that are bonded together have different electronegativites, then you can determine how polar a particular bond is by finding the difference in the bonded atoms’ ELECTRONEGATIVITIES.

COMPRESSIBILITY FACTOR =pv/nrt

It's ALSO equal to ratio = molar volume of Real GAS/molar volume of IDEAL gas

So Z(compressibility factor)=V(Real gas)/V(ideal gas)

Both has groups and periods IE VERTICAL columns are groups and HORIZONTAL rows are periods

The MASS of one equivalent of the DIHYDRATE would be HALF that, or 63 g/mole, not because it is a dihydrate, but because it is diprotic. ... Oxalic acid, H2C2O4*2H2O (molar mass = 126.07 g/mol) is oftenused as a PRIMARY standard for the standardization of a NaOHsolution.

Al2Cl3 is the FORMULA for ALUMINIUM chloride.
1 mole of any substance CONTAIN 6.022*10^23.
molar MASS of aluminium chloride is 160.5
number of atoms present = 6.022*10^23 ×give mass÷molar mass.
= 3.75×10^22.

Normality=W/GEW *1000/V. 0.2=W/49 *1000/500 W=0.2*49/2=4.9gm GEw of H2SO4=Gmw/basicity.
=98/2
=49

It's ENTHALPY of DECOMPOSITION is too HIGH

...,.,.,.,.........,.,.,.,.,.,.,.,.,..,.,.,.,.,..,.,.,..,.,..,.,..,.,.,..,,.,..,..,.,..,..,.,.,.,..,,..,.,.,..,.,.,..,.,.,.....,..,.,..,.,,.., NM , , ,. , , ,.

In rushting METAL get eaten AWAY and COMBINE TION APRODUCT can burn

This your question lacks IMPORTANT information but I would like to give you some highlight about it.

This question is testing the idea is electrochemistry as well as REDOX REACTIONS and in some books it is referred to as competition processes.

So it requires you to consider the change in oxidation state of Bromine CORRESPONDING to different electromotive force, emf values as per the diagram.

So all you need to do is to calculate E°cell corresponding to each compound under going DISPROPORTIONATION reaction.

If the reaction for which E°cell comes out +ve is spontaneous.

Shodingers WAVE EQUATION

Wavelength =h/mv h=6.625*10(-34) M2.Kg/sec. mass=60*10(-3)kg. Velocity =10metere/sec. wavelength =6.625*10(-34) /60*10(-3)*10 =1.1041*10(-33) METERS