1.

Write precautions while working on an Immersion Rod.

Answer»

1. Before testing water heater, insulate yourself on the dry wood. 

2. Test the water heater in series of the electric supply to avoid the risk of failure of supply. 

3. Never give direct supply unless you are sure that there is no fault in the water heater to avoid the risk of failure of supply. 

4. Use three-wire cord for the supply. 

5. The water should be switched on to mains only after it is dipped in the water. 

6. Dip the water heater up to the indicated mark and don’t allow terminal housing to be immersed in water. 

7. First switch off the current then remove water heater from the water. 

8. Don’t take out the rod from water at once as soon as you switched off the supply. 

9. Don’t use the immersion heater in other liquids because it is meant for water only and in other liquids, it will have a corroding affect on its surface.



Discussion

No Comment Found

Related InterviewSolutions