Saved Bookmarks
| 1. |
While turning taper using turning attachment, the setting was done for 4∘, but the tool is set 2.5 mm below the centre. If the workpiece diameter at the small end is 35 mm. Possible error in taper angle will be _______min.1.81 |
Answer» While turning taper using turning attachment, the setting was done for 4∘, but the tool is set 2.5 mm below the centre. If the workpiece diameter at the small end is 35 mm. Possible error in taper angle will be _______min.![]()
|
|