Solve : Strike F1 to continue or F2 to enter setup utility?

1.	Solve : Strike F1 to continue or F2 to enter setup utility?
Answer» I'm GETTING this message after the BIOS finishes and the PC will not open winXP until I strike F1. How do I bypass this? I have same problem on two PC's after REFORMAT and new install of OS.Look up in your BIOS set-up menu for an option "Halt on", save and exit. There might be some hardware failing. Post for any result.Do you have your hard drives plugged into a RAID card?On one pc I am connected to a raid card but not the other.On BIOS set-up: If options/features are available. 1. Reset Config DATA --> Reset once. Reboot and check. 2. PCI Delay Transaction --> Enable. Reboot and check. If default is enabled then disable. 3. Halt on error --> If any failing hardware. 4. Quick boot --> Enable.

Discussion