1.

In a turning process using orthogonal tool geometry, a chip length of 100 mm is obtained for an uncut chip length of 250 mm. The cutting conditions are cutting speed = 30 m/min, rake angle = 20°.The shear plane angle is degrees (round off to one decimal place).

Answer» In a turning process using orthogonal tool geometry, a chip length of 100 mm is obtained for an uncut chip length of 250 mm. The cutting conditions are cutting speed = 30 m/min, rake angle = 20°.

The shear plane angle is degrees (round off to one decimal place).


Discussion

No Comment Found

Related InterviewSolutions